Eagle TT Series, Parts And Service Manual

Page: 71 / 166

71
REV23 4.14.15 TT10-12 4TNV98T
A
XLE
- F
RONT
AXLE ASSEMBLY BREAKDOWN—FRONT DRIVE CONT.
(1) Due to engineering change by Dana axles. Your tug may have either a 30 or 35 tooth shaft and joint assembly.
All tugs with continental engines will have 909218-7 (35 tooth). It may be necessary for you to count the teeth on
your shaft and joint assembly to correctly identify the part you require.
(2) Note—If cotter pin cannot be installed after minimum torque is attained, the nut must be advanced until cot-
ter pin can be installed.
(3) When replacing steering knuckles be sure that upon installation your steering cylinders (see pages 48-51) must
be adjusted so when in full turn to the right and then full turn to the left the cylinder does not pull steering arm
more than 3/16 of an inch. If you have any questions please call Eagle Tugs technical department.