SUBJECT
REF. MDL.
REPORT NO.
INSTRUCTIONS FOR CONTINUED AIRWORTHINESS
GA182
ICA182-2
Rev. A
10/15/12
SEE NON-DISCLOSURE NOTICE ON THE COVER PAGE
26 of 101
Copyright 2012
Eagle Copters
All Rights Reserved
Parts List for Figure 15:
I/N
QTY
PART NUMBER
DESCRIPTION
-
1
G12370
Backplane
-
1
G12320
Shell
-
1
G12371
Case
-
1
G11426-3
Side Cover
-
* [a]
G11426-4
Cover Plate
-
* [a]
G11426-8
Wire Guide Cover Panel
-
1 [b]
G11427
COM1 Direct Board
-
1 [b]
G11437
Relay Module Board
-
* [a]
G11428
Audio Board
-
* [a]
G11429
ICS Audio Board
-
* [a][c]
G12358
Headset Expander
-
* [a][c]
G11430
Audio Expander
-
* [a]
G12266
Dimmer Module
-
1
G11700-8
Backplane Insulator
-
1
G11701-8
Backplane Insulator
-
1
G12538
GNET Config Port
* [a] Quantities and positions for these components may change depending on the
installer’s desired configuration requirements.
* [b] Audio systems shall be fitted with either one G11427 COM1 Direct OR G11437
Relay Module
* [c] Audio systems shall be fitted with either G11429 ICS Audio Board OR G12358
Headset Expander Boards
4.3
Analog Router Reinstallation
a.
The router may be mounted into a rack, such as the
Eagle Audio
P142
Modular Equipment Rack (STC # SR00474SE). It also may be
mounted to an aircraft structure that is designed to carry the load of the
router (11 lbs). Since installation will vary depending the aircraft
configuration, the installer is responsible for receiving FAA approval for
the mounting of the router to the structure if not previously approved.
Two G12340 Brackets may also be used for mounting the router to the
aircraft structure.