Connecting and audio input and output
If the G920D is to be used to attenuate the audio signal (rather than to switch
equipment on and off) then connect the audio input to the terminals labelled “AUDIO
IN” and the audio output to the terminals labelled “AUDIO OUT”. The circuitry is
designed for a balanced line input and output. If an unbalanced signal is used, use the
“+” and “0” terminals, connect the “
−
” input to 0, and ignore the “
−
” output.
Remote Reset
The G920D can be set either to disconnect the audio for a fixed period of time and
then reconnect it, or to disconnect the audio until a remote RESET switch is pressed.
To use the REMOTE RESET method, set the REMOTE RESET switch in the centre of
the control panel to the ON position, and connect a momentary switch to the pair of
terminals labelled “RR”.
G920D User Guide
- page 7 -
−
+
0
0
+
−
−
+
0
0
+
−
Right Channel Output
Left Channel Output
Right
Channel
Input
Left
Channel
Input
To remote
reset switch
