5
For Wiring Diagram B installations, remove the Uniden adapter
segment at the end of your data cable as shown at left. Snip off the end
of the cable protected by the black heat-shrink. At right, we have used
clear heat-shrink for clarity, so you can see the diode and resistor
protected within. Remove this portion of the cable.
After you have removed the adapter segment, use wire pliers to expose
the ends of the five remaining wires in the cable. Cut off the black, blue
and white wires, then seal their ends with electrical tape.
After removing the adapter segment, prepare to connect by removing
and taping off unneeded wires. Strip the end of the yellow wire.
Strip about 1/4-inch (6.35 mm) of insulation from the yellow wire, then
follow the preceding wire nut and taping instructions to connect the
wires from the radio or other device.
Black
Blue
White
Cut black, blue
and white.
Yellow
(transmit)
Bare wire
(shield)
Summary of Contents for CUDA 250 S/Map
Page 10: ...10 Notes...
Page 11: ...11 Notes...
