E
E
a
a
g
g
l
l
e
e
E
E
q
q
u
u
i
i
p
p
m
m
e
e
n
n
t
t
S
S
S
S
7
7
0
0
0
0
0
0
S
S
e
e
r
r
i
i
e
e
s
s
L
L
i
i
f
f
t
t
s
s
1-800-336-2776
SS7000-23
www.eagleequip.com
Apply compressed air to the vent fitting to extend ram to approximately 18” from the opposite
cross rail. (Apply air gradually from 0 psi to the minimum pressure necessary – 45 psi max - to
slowly
extend the ram. Do not apply air at high pressure, as this may damage the ram).
Remove any hardware installed to extend the ram. Locate the cable holder (thick plate), the
cable retainer (thin plate). Locate the 1” locking nut and washer from Bag E, and the hydraulic
fittings from Bag D.
Install the cable holder on the ram. Install the cable retainer on the ram. Place the 1” washer and
nut on the ram. Tighten the nut two to three complete turns on the shaft.
If you have successfully extended the ram using the compressed air method, skip the following
section.
Cable
holder
Cable
retainer