EAE EE-6605S, Installation, Operation, And Parts Manual

Page: 15 / 31

Installation, Operation and Parts Manual
EE-6605S/A/B
15
5.3 Operation instructions
To avoid personal injury and/or property damage, permit only trained personnel to operate the lift. After reviewing these
instructions, get familiar with lift controls by running the lift through a few cycles before loading vehicle on lift. Never raise just one
end, one corner or one side of vehicle. NEVER raise just one end. Do not attempt to transport a load on the lift. The lift must be
only used in a static position for lifting and lowering vehicles.
Raise the lift
Make sure vehicle is neither front nor rear heavy and center of balance should be centered over the lift.
1. Make sure that you have read and understood the operation manual before operation.
2. Drive and park the vehicle midway between two platforms.
3. Push the “UP” button to raise the lifting platform a little bit off the ground and check the stability of the lifted vehicle.
4. Having raised the vehicle to the expected height, push the “Safety Lock” button to ensure the mechanical safety lock is engaged. Check
again the stability before performing maintenance or repair work.
Lower the lift
When lowering the lift pay careful attention that all personnel and objects are kept clear.
1. Turn on the power switch.
2. Push “DOWN I” button to lower the lift. It will stop lowering at proper height off the ground.
3. Push “DOWN II” button to continue lowering the platforms which accompanies with safety alarming buzz.
4. Drive the vehicle away
POS. Name Function
FA Alarm buzzer Low height alarm
SB1 UP button Control the rising movement
SB4 LOCK button Engage the safety locks
SB2 DOWN button Control the initial lowering movement
SB3 DOWN button Control the secondary lowering movement
SB Emergency stop Stop power in emergency cases
HL Power indicator Show if power is on
QS Main switch Power on /off
SA1 Selection switch Select working or leveling condition