EAE EE-6603S, Installation, Operation, And Parts Manual

Page: 14 / 39

Installation, Operation and Parts Manual
EE-6603S/EE-6603B
14
Attention 2: Before hoisting, make sure the hoses and wires are well protected against damage.
Attention 3: It is necessary to hold the platform during the hoisting process. Irrelevant person is not allowed in installation area.
Step 2: Connect hydraulic system.
Connect the oil hoses fittings to the power unit as per the diagram for oil hose connection. Annex 3.
Attention: Connect as per the marks on the hoses and do not contaminate the hydraulic components during the connection.
It must be taken adequate care that all fittings are securely tightened. Severe leaking will occur if the hose fittings are not properly
tightened.
Step 3: Connect the pneumatic release system
Connect the pneumatic release system by the diagram of air hose connection in Annex 4.
Attention: Do not contaminate the pneumatic components during the connection.
Set the pneumatic pressure between 6-8 bars.
Push upward the button indicated in the following fig and turn the button until the hand of the pressure meter points to the
NUMBER ”6” . Push the button down thereafter.
It is suggested to add ISO VG32 mechanical oil into the oil tank.
Adjust the oil dipping quantity using the button on top of the oil cup.
Set with the arrow mark pointing to the NUMBER”4”
Step 4: Connect electrical wires.
Electrical connection must be done by qualified electricians.
Refer to Annex 2 when fix the electrical system.
Connect the wire connectors for raising and lowering limit switches
Connect the power supply cable to external electricity supply.
(For three phase power supply, if the lift doesn't raise and the motor may turn in the wrong direction, in such event, interchange wires U,
V in the control cabinet).
Step 5: Fill with hydraulic oil.
ONLY CLEAN AND FRESH OIL ONLY .Lift must be fully lowered before changing or adding hydraulic oil.
Pour 16 liters anti-abrasion hydraulic oil into the oil tank. The level of oil shall reach the tippets volume mark of the tank.
Run the lift for several cycles and add more oil until the lifting platform can reach its maximum height.
Note
：
It is suggested to use HM NO.46 hydraulic oil. Use HM NO.32 hydraulic oil when temperature is below 10 degree Celsius.
Change the oil 6 months after initial use and change once per year thereafter.