Water Sensing Cable
LP-LPD Water Leak Locating Panel Quick Start Guide
Page 8 of 10
Clock Setup for LP-LPD
As shown in the figure below, click "Read System Time" to read and indicate the current computer system
time in the clock display box; click "Write into Module" to write the time in clock display box into the
LP-LPD module; click "Read Module Time" to read the time of LP-LPD module and then indicate it in the
clock display box. You can also enter the desired time into the clock display box and click "Write into
Module" to correctly set the LP-LPD time.
Maintenance & Troubleshooting
Each Panel is well tested before shipment.
State Display
The LP-LPD is equipped with 5 LEDs that respectively indicate power supply, communication (RX =
RECEIVE, TX = TRANSMIT), detected leak, and fault of sensing cable.
When LP-LPD is powered on and runs properly, the red power LED is ON; Table 1 shows various status of
sensing cables and the corresponding possible corrective actions. Table 2 shows various communication
status (ideal for LP-LPDs in the connected network system)
