Eachine E160 User Manual Download Page 6

Right hand throttle                                       Left hand throttle

This remote control supports CCPM 120 degree helicopter dedicated remote control, 
with 3D 6G switching high/low rudder capacity for two joystick modes, flameout switch 
(TH.HOLD) and other modes, large screenLCD display multi-function remote control.

FLIGHT BATTERY INSTALLMENT

1.  Put the throttle joystick to the bottom position.
2. Turn on the transmitter.
3. Install the battery into the rack and connect it properly with the receiving power.
4. Once the battery is connected, the signal starts to blink. Keep it still and wait until the 
    signal light stops blinking, which means the receiver has completed self-inspection and 
    gets ready for flight.

TROUBLESHOOTING

Problem

LED on receiver flashes

constantly with no responses

after connecting batteries to

transmitter.

The helicopter has no

response after connecting

batteries to receiver.

When push the throttle

pole, the rotor do not

rotate and the LED on

Receiver flashes

cons tantly.

Helicopter takes off

immediately, once

the batteries and

receiver connected.

Cause

Solution

Put the throttle pole at

the lowest position

before open the

transmitter.

Didn't put the throttle to

the lowest

Low battery voltage;

batteries connection

is not good. 

Check whether the

transmitter and

receiver connecting

to power; check the

voltage of transmitter

and receiver; Battery

pole flake contact is

not good.

Transmitter is not bound

to receiver.

Pairing of the transmitter 

and receiver failed.

Replace and charge the

batteries, reconnect the

batteries to the receiver

board.

Open the transmitter,

make sure the batteries

connecting is good

Replace and charge

transmitter batteries

Make sure the battery

pole flake contact is good. 

Re-pair (Refer to P.5, 

Programming your

Transmitter)

1

2

3

4

ABOUT REMOTE CONTROLLER

- 8 -

- 9 -

Summary of Contents for E160









Reviews: