EA3GCY EGV-9B v1, Assembly Manual

Page: 22 / 35

EGV-9B
80 to 10m QRP CW Transceiver Kit Page 22
 IC12
SI5351
The IC12 is a module that incorporates the SI-5351 frequency generator
Solder the elbow 7-pin strip and solder the module onto the board.
Make sure that the module is vertically with the board as shown in the images.
 IC13
OLED 1.3” display
This is the display for the EGV-9B . It may be best not to place it to the end.
Before placing it, you must think and be sure how to install the EGV-9B in your enclosure.
The OLED display use a strip of 7 pins at right angles to solder the module onto the board.
When solder, you can adjust the distance a little to match the front panel of the enclosure (See the
EGV-
9B BOX manual.