EGV-9B
80 to 10m QRP CW Transceiver Kit
Page 20
- Cut the ends and separate the two windings.
- Use a sharp knife to scrape the enamel off the ends that will be soldered. The ends of the coils that we
have made need to be prepared in this manner before soldering them into the board.
-
Using a multimeter in its ohm or continuity function, locate and mark the ends, identifying them as “a” -
“a1” and “b” - “b1”.
- Mount the toroid into the appropriate holes as marked on the circuit board.
Note: For greater clarity, the drawing shows one black wire and one red wire. In reality, both wires are of
the same color. You can mark the "a" -"a1" with a marker pen.
Summary of Contents for EGV-9B v1
