11/40
E-XTEQ
DS ONE
User Manual / Ref. MAN_DSOne_STL_EN_V1.3
Initial Setup
1/9
POWER CABLE CONNECTION AND POWER ON ////////
DS One is equipped with a Lithium-Ion Polymer Rechargeable Battery. To recharge
its internal Li-Po battery, the DS One is equipped with a transformer (110-220V) and
worldwide power adapters.
Voltage
100 – 240 V
Frequency
50/60 Hz
Consumption
0,3A Maximum
Before using the DS One for the first time, it is recommended to fully charge the
internal battery. When the DS One is connected to a power supply, it will start
automatically.
Connect the USB B
side power cable to
the DS One.
Connect the USB A
side power cable to a
USB port.
Or use the switching
adapter by putting
the corresponding
plug adapter for your
installation.
Connect the USB
socket A to this one.
Plug into a standard
electrical socket.
When the battery is full, the logo on the DS One display will change from charging to full.
It is recommended to charge before use.
BATTERY CABLE CLAMPS CONNECTION ////////
Connect the clamps on the side of the remote.
To connect the clamps on the side of the remote, position
the connector, then push it lightly in position and screw it
on. The connector has only one position, the angle of the
cable must be towards the bottom of the DS One.
Table of Contents
Introduction
Safety Guidelines
Maintenance and Storage
Before Use
Usage Precautions
Disassembly/Damage/Removal
Cleaning the Product
Information internal battery
Safety Reminders
Appearance and Dimensions
Presentation
Job Storage
Accessories
Positioning of the clamps
Connector longevity
Hybrid vehicles
Power Cable Connection and Power On
Battery Cable Clamps Connection
Optimus
- Optimus installation
- Using Optimus
Update
Garage code (RRDI)
Preferences
WI-FI Connection
Other settings
Battery selection
- Using BK code
- Using VIN
Start Diagnostic
Other diagnostics
Results
Results storage
Support Information
Warranty
Technical specifications
See “Best Practices”.
