9
10
6.USEING AND OPERATION
6.1Using
6.1.1
Controller: an absolutely necessary electrical device. All electronic components
to operate the wheelchair are integrated to the device.Usually, the controller is
installed on an armrest, connected together with the motors and batteries to the
power box.
●Switch button: Switch button supplies the
●
Charger Socket:It is only used to this wheel-
chair. Do not use the socket to supply power to
any other electrical equipment. Otherwise, it may
damage the
wheelchair’ s control system or its
E.M.C performance (Electromagnetic tolerance).
power for control system for electronic equip-
ment, then equipment supplies the power for
motor of wheelchair. Do not use the switch
Battery indicator
Charger socket on the base
Power switch
button to stop the wheelchair unless an emer-
gency situation. Otherwise it may shorten the life
of the wheelchair drive components.
●Joystick: The joystick is mainly used to control
the wheelchair’ s movement including its speed
and direction(forward, backward and left or right
etc). The further you push the joystick from its
central position, the faster the wheelchair
moves. Whenever you release the joystick, it will
automatically go back to the center and the
brake will be automatically operative to stop the
wheelchair.
●Horn button: The horn will sound if you press
this button.
●Speed Up/Down Buttons and Speedometer:
After turning on the power, the speedometer
shows the current maximum speed setting. This
maximum speed setting can be adjusted through
the speed up button or speed down button by
user.
Horn button
Speed indicating light
Speed down button
Speed up button
Joystick
6.1.2
Batteries and Its Usage
Fully charge your new battery prior to its initial use. This brings the battery up to
about 90% of its peak performance level; Give the battery another full charge of 5-8
hours and operate your wheelchair again, the batteries will now perform at over 90%
of their potential; After four or five charging cycles, the batteries will top off at 100%
charge and last for an extended period. Please replace a new battery when the bat-
tery failure, and the used battery must be returned to supplier because of environ-
mental pollution.
Battery specification
Type
Lithium battery
Dimension
12.6
’’*3.15’’*2.56’’
Voltage
24V
Amperehour
10AH
6.1.3
Charger Usage
The battery charger is an important part of the wheelchair. The off-board charger
attached to this product can charge its batteries quickly and easily to make your
wheelchair the best.
0 ~3.4MPH
0 ~3.1MPH
0 ~ 2.8MPH
0 ~2.5MPH
automatically.(fig.E)
the control system, then the warranty is invalid.
