11
12
Please note below tips when charging:
●Be certain the controller is powered off and the wheelchair is in the electric mode,
instead of the manual mode.
●Connect the 3-pin output plug of the charger to the controller. (Fig.14)
●Connect the power plug of the charger to the standard wall outlet.
●
The red LED on the charger lights indicating that charging is in progress. The
green LED on the charger lights when the batteries are fully charged.
●We recommend you to charge the battery for 5-8 hours.
●Remove the charger and power plug when fully charged, and put them into the bag
behind the seat rest.
6.1.4
Safety Belt
For your safety, the safety belt must be fastened before you operate the wheelchair.
(fig.13)
6.2 Operation
6.2.1 Preparation before operation
●Do not turn on the power switch when sit on the power wheelchair, and do turn off
the power switch when get off from the wheelchair.
●Please fold the pedal first then hold the armrest to sit on the wheelchair; Do not get
off the wheelchair by stepping on the pedal. Otherwise the wheelchair maybe turned
over, which is dangerous.
6.2.2 Practice before operation
●Find a spacious place like square and have an assistant to help you practice until
you have enough confidence to operate it.
●Be certain to shut down the power when up and down the wheelchair, and set a
speed you need through speed adjustment button.
●We recommend you set the lowest speed until you can operate the electric wheel-
chair skillfully. (fig.a)
●
To practice the stop operation, forward and backward. Push the handle, the wheel-
chair move to anywhere you want.(fig.b)
●
Firstly, ensure that it is the lowest speed when practice forward operation. After
Skilled, you can practice “S” shaped turn. After you are familiar with "S" shaped turn,
to practice backward operation, and pay attention to the speed control setting. And
the backward speed should lower than forward speed.(fig.c)
6.1.5 Overload and Undervoltage Protector
The overload and undervoltage protector is set for the wheelchair’ s safety, and
implement the protection function through the on-off of the protective board installed
inside the lithium battery. Once motors overload or undervoltage, it will trip to cut off
the power to prevent the motors and electric components from damage. The protec-
tor function could be recovered by charging the wheelchair or reconnect the batter-
ies.(fig.14)
Forward
Left
Right
Backward
fig.a
Start at
the lowest
speed
fig.b
fig.c
