10. INSPECTION AND MAINTENANCE BEFORE RIDING
(Please refer to the components location diagram for the following components.)
ROUTINE INSPECTION
Check Items
Check Key Points
Engine Oil
Is there enough engine oil?
Fuel
Is it enough?
Front
Braking condition?
(Brake lever free play: 10~20mm)
Brake
Rear
Braking condition?
(Brake lever free play: 10~20mm)
Front
Is tire pressure normal?
(Standard: 1.75kg/cm
2
)
Tires
Rear
Is tire pressure normal?
(Standard: 2.0kg/cm
2
for 1 person, 2.25kg/cm
2
for 2 persons)
Steering Handle
Does the handle vibrating abnormally or is difficult to turn?
Speedometer, lights, and
rearview mirror
Is it operating properly?
Do lights come on? Can it be seen clearly from behind?
Tightness of Main Components
Are screws, nuts loosen?
Abnormal Points
Do the previous troubles still exist?
CAUTION:
If any problem found during routine inspection, correct the problem before using the motorcycle
again, have your motorcycle checked and repaired by the
“E-TON authorized dealer”
if
necessary.
ENGINE OIL INSPECTION AND CHANGE
INSPECTION:
1.
Use the main parking stand to support the motorcycle
on a level ground, remove the dipstick after engine
stopped for 3~5 minutes. Wipe oil off the dipstick and
then insert it into the guide tube again (Do not rotate it.)
2. Remove the dipstick and check whether oil level is in
between the upper and lower marks.
Add oil to upper limit if oil is under the lower limit.
(Check cylinder, crankcase…etc for leakage.)
13
Copyright ©2008-2009 ETON America, all rights reserved.