2
FIGURE 2
IIIINSTALLATION
NSTALLATION
NSTALLATION
NSTALLATION
The unit has a sensing angle of approx. 110° and can
detect up to 10 meters at the mounting height of 1.7
meters. (FIGURE 3)
0
2
4
6
8
10
2
4
6
8
10
0
2
4
6
8
10
FIGURE 3
WIRING INSTRUCTION
WIRING INSTRUCTION
WIRING INSTRUCTION
WIRING INSTRUCTION
Important Note: Only One PIR Sensor per lighting
circuit to be used.
(1) Switch off the power source.
(2) Remove the battery cover by sliding and lifting it
off. (FIGURE 4)
FIGURE 4
(3) Fit the 3.7V Lithium battery supplied to the battery
compartment, ensuring that correct polarity is put.
Refit the battery cover. (FIGURE 5)
FIGURE 5
(4) Strip approximately 6-8mm insulating part of the
wires from the power cord.
(5) Connect the BROWN wire (Live wire) of power
cord to the terminal block "L" mark.
Connect the RED wire of lamp wire to the terminal
block " L’ " mark. (FIGURE 6)
FIGURE 6
(6) Fit the main body to the wall box and secure it
with two fixing screws provided. (FIGURE 7)
FIGURE 7
SETTING THE LIGHTING SYSTEM
SETTING THE LIGHTING SYSTEM
SETTING THE LIGHTING SYSTEM
SETTING THE LIGHTING SYSTEM
(1) TEST MODE
Note:
It is capable of detecting whether AC mains
supply has been connected. If it is not
connected to AC mains supply, it will enter
sleep mode so as to conserve battery power.