ELBCam
1
- Technical Documentation
10.04.2007 © E.L.B. Ex-Geräte Bachmann GmbH & Co. KG Page 3
Special notes concerning the explosion protection:
•
In a hazardous area the locking bag for USB and battery cover must be used.
•
Do not open the USB or battery cover in hazardous areas.
•
Do not take the USB lead or other accessories into explosive areas. (Neck
loop and carrier bag allowed.)
•
Ambient temperature -20°C ... +50°C
•
Pay attention to the technical data and the safety advice!
2 Delivery
Components
Delivery includes:
•
USB
photo
camera
ELBCam
1
•
2 alkaline battery cells size AAA
•
USB lead (not allowed in a hazardous area !)
•
Manual for the Ex version
•
Manual for the Non-ex version (on paper and DVD)
•
Driver for Windows 98 on DVD (driver for higher versions not necessary)
•
Locking bag for battery and USB cover
•
Carrier bag with belt clip and neck loop
3 Operating
Please note the safety advices and the data for hazardous areas use !
For additional information concerning operating and optical data refer to the manual
of the Non-Ex version enclosed with the camera. The buzzer, which is mentioned
there, has been removed however.
Taking photos:
•
Press the button on the back of the camera for 4 seconds. Camera operation
starts with one flash of the red lamp and the blue lamp flashing continuously.
•
If the camera does not start after about 5 seconds, please try again. If it does
not start at all, please exchange the batteries (not allowed in hazardous
areas).
•
Chose between standard distance and close-up with the macro switch.
•
Press the button again, but only briefly to take a photo. The blue lamp on the
side is continuously on now. Up to three seconds later the photo is taken
depending on the subject, illumination and motion. The blue lamp stays on
until the photo taking process is completed and the picture edited
(compression and saving).
•
The camera is ready again, when the blue lamp starts to flash.
•
The camera switches off automatically after about 90 seconds without
pressing the button.
