24
8. Install one of the .046" x 6
1
/
4
" rods through
the hole in the center of the side force generator
and into the fuselage spine. Leave at least
1/16" of the rod exposed on the outside of the
side force generator. Glue the rod only to the
fuselage spine.
Note
: There is a small notch in the spine for the
location for the carbon rod.
9. Use a straight edge to make sure the side
force generator is not bent in or out on the
wing. Glue both sides of the rod to the side
force generator.
10. Repeat Steps 8 and 9 for the remaining
center rod.
Summary of Contents for Tensor 4D
Page 1: ...Assembly Manual Tensor 4D...
