Motor Installation
Required Parts
• Wing
• Motor (2)
• Brushless speed control (2)
• 2mm x 6mm screw (4)
• Red wire, 25" (680mm) (2)
• Black wire, 25" (680mm) (2)
• Foam motor nacelle (right and left) (2)
• Wiring decal
• Heat shrink tubing: 1/4" (6mm)
Required Tools and Adhesives
• Phillips screwdriver • Flat blade screwdriver
• Soldering iron
• Solder
• 30-minute epoxy • Rubber bands
• Hobby knife
• Small round file
• Model clamps
1. Route the motor wires through the pre-drilled
holes in the fan housing.
13