11. Run the motors at full throttle and look for any
rubbing of the fan blades to the outer shroud.
If any rubbing occurs, you can remove the fan
rotor assembly and work the area with a rotary
tool and a fine drum sander until all the black
area is removed. Remove very little, maintaining
the circumference of the shroud. Reinstall the fan
rotor assembly and run again. There should be
no rubbing at all during operation.
Landing Gear Installation
Required Parts
• Wing
• Fuselage
• Servo
• 12" servo extension
• Main gear assembly (2)
• Nose gear assembly
• 2mm x 8mm sheet metal screw
• 1/2" x 3/8" x 3/8" (13mm x 9.5mm x 9.5mm) servo
mounting block (2)
Required Tools and Adhesives
• 1.5mm hex wrench • File
• 6-minute epoxy
• Pencil
• Threadlock
• Hobby knife
• Medium CA
18