Ο 2. Place the wing center section inverted on the work
surface. Lower the fuselage onto the center section
and align the upper ends of the cabane struts with
the mounting locations. Use a 3/32-inch balldriver
to install the four 4-40 x 3/8-inch Allen bolts and
#4 washers. Apply a small amount of threadlock to
the bolts to prevent them from vibrating loose.
Aileron Servo Installation
Parts Required
Lower wing panels (L and R)
Micro servos with hardware (2)
2mm x 10mm sheet metal screws (8)
Servo mounting blocks (4)
Control horns (2)
Radio system
JR MatchMaker
Tools Required
Philips screwdriver #0
6-minute epoxy
Mixing cups
Mixing sticks
Paper towels
Rubbing alcohol
Thin CA
Medium CA
Pencil
Sidecutters
Pin vise
1/16-inch drill bit
Low-tack tape
Ο 1. Prepare the aileron servos by installing the
rubber grommets and bushings.
Ο 2. Use a #0 screwdriver to remove the small arms
from the servos. Using sidecutters, remove three
arms from a larger servo arm, leaving one long
arm. Center the servos using your radio system or
JR MatchMaker and install an arm on each servo,
one opposite to the other.
ΟΟ 3. Remove the aileron hatch from the wing.
E-flite Stearman PT-17 15e ARF Assembly Manual
1
122
