28
Rudder and Elevator Servos
Required Parts
Fuselage
Plastic rudder horn
2mm x 4mm screw (3)
Pull-pull cable
3" (75 mm) pushrod wire
Brass cable keepers (4)
Micro control horn w/backplate
Micro control connector w/retainer (3)
Servos: JR 241 Sub-micro Servo (JRPS241) (2)
12" (305 mm) servo extension
Micro cable adjust connector (2)
Required Tools and Adhesives
Phillips screwdriver (small)
Hobby knife
Medium CA
Thin CA
1. Install the grommets and brass eyelets in the elevator
servo. Secure a 12" (305 mm) servo extension to the
servo. Mount the elevator servo using the hardware
provided with the servo.
2. Use a hobby knife to enlarge the center hole in one
of the remaining control horns. Attach the 3" (75mm)
pushrod wire to the control horn.
