35
1. Check to make sure all servo wires and ESC wires
can reach the location of the receiver before
mounting the receiver. Cut a piece of the hook and
loop tape to the size of the receiver. Install the
receiver using the hook and loop. Plug in the
rudder, elevator, and aileron servos. Route the
receiver antenna to the rear of the plane.
Note
: Do not cut the receiver antenna,
as this will greatly reduce the range of the
radio system.
Hint
: Position the receiver so the ailerons can
be plugged in easily.
2. Use hook and loop material to mount the electronic
speed control. Attach the ESC to the inside of the
fuselage to provide room for the motor battery.
