15
E-flite Enticememt F3P Profile Assembly Manual
Servo Installation
Required Parts
Airframe assembly
Control horn support (3)
Rudder control horn support Heat-shrink tubing (4)
1/16 x 13/16-inch (2mm x 20mm) carbon control horn (4)
4-inch (103mm) carbon pushrods (2)
14
7
/
16
-inch (370mm) carbon pushrod (1)
15
5
/
8
-inch (398mm) carbon pushrod (1)
Plywood pushrod supports (4)
Required Tools and Adhesives
Foam-safe CA
Foam-safe CA activator
Low-temperature hot glue
Hot glue gun
Soldering iron
Hobby knife
1. Use a ruler to measure 9/16-inch (15mm) on each
of the four 1/16 x 13/16-inch (2mm x 20mm) carbon
control horns. Use foam-safe CA to glue each of the
control horn supports to the rods with the bottom edge
of the support 9/16-inch (15mm) from the top of the
control horn.
Note
: The rudder control horn support is longer than the
aileron and elevator supports. This longer edge faces
away from the control horn as shown in the photo.
