18
E-flite AT-6 Texan ARF Assembly Manual
8. Use hook and loop tape to install the receiver in the
fuselage following the manufacturer's instructions. A
tube has been installed inside the fuselage to route the
antenna wire.
Do
not
cut the receiver wire if it extends
excessively outside the fuselage as this will greatly reduce
the range of your radio system.
9. Physically center the rudder. Use a felt-tipped pen to
mark the rudder pushrod where it crosses the outer hole
of the rudder servo arm.
10. Remove the rudder pushrod from the fuselage and
make a 90-degree bend in the pushrod at the mark
made in the previous step using pliers. You will also have
to remove the clevis at this time as well to reinstall the
pushrod.