14
E-flite Alpha Sport 450 PNP Assembly Manual
AILERON ThROW
5. Use a ruler to check the control throws on the
ailerons. The dimensions are shown below. For
your reference the aileron pushrods are set up in
the following holes: the middle hole on the aileron
control horn and the outside hole on the aileron
servo arm.
6. From center, use a ruler to measure the movement
of the ailerons. Make sure the ailerons move up
1/2-inch (12mm) from center and down 1/2-inch
(12mm) from center. Measure both the right and left
ailerons to make sure they are working in unison.
This is the setting for the high rate.
7. From center, use a ruler to measure the movement
of the ailerons. Make sure the ailerons move up
1/4-inch (6mm) from center and down 1/4-inch
(6mm) from center. Measure both the right and left
ailerons to make sure they are working in unison.
This is the setting for the low rate.
ELEvATOR ThROW
8. Use a ruler to check the control throws on your
elevator. The dimensions are shown below. For
your reference the elevator pushrod is set up in the
following holes: The outside hole on the elevator
control horn and the outside hole in on the elevator
servo arm.
9. From center, use a ruler to measure the
movement of the elevator. Make sure the elevator
move up 1/2-inch (12mm) from center and down
1/2-inch (12mm) from center. This is the setting for
the high rate.
