PROGRAMMING
3-13
Revised January 2001
Part No. 001-7780-501
Figure 3-3 Conventional Channel Screen
4. Click the Modify button to display the screen which
enables that channel and programs the alias (tag)
and transmit and receive frequencies. Then program
the other parameters in the main part of the screen.
Refer to the next section for more information.
3.5.4 CONVENTIONAL CHANNEL SCREEN
PARAMETERS
The following parameters are programmed in the
conventional channel screen shown in Figure 3-3.
Selected Channel
Zone Box - Clicking the arrow to the right of this
box displays the available zones. Click on a zone to
select it. Zones and zone aliases are set up on the
Radio-Wide General screen described in Section
3.4.2.
Channel Index Box - Displays the available chan-
nels in the selected zone. The channel type is
selected by the Channel Type box below it.
Modify Button - Displays the small
screen shown in Figure 3-3 which enables the
channel (makes it selectable) and programs the alias
(tag) and transmit and receive frequencies.
The parameters in this screen are as follows:
Channel - Selects the channel to be edited.
Alias - Programs the identification that is displayed
when the channel is selected. Up to 8
characters can be programmed.
Transmit - Programs the transmit frequency of the
channel.
Receive - Programs the receive frequency of the
channel.
Enable This Channel - The box must be checked for
the channel to be selectable.
Rx Only - The box is checked if the channel is
receive-only (transmitter disabled).
Copy Parameters From Channel - If another channel
is selected, the parameters from that
channel are copied to the new channel.
NOTE: Channel numbers not assigned must be
programmed for conventional operation and then not
enabled in the Modify screen because SMARTNET/
SmartZone channels cannot be disabled.
