PROGRAMMING
3-15
Revised January 2001
Part No. 001-7780-501
System ID - Read-only field which shows the ID of
the system currently being edited.
SMARTNET/SmartZone System General
Screen
Splinter Channels
When splinter channels are enabled, the receive
and transmit frequencies are 12.5 kHz lower than the
normal frequencies. Splinter channels are used only as
required in the Mexico and Canada border areas for
frequencies between 806 and 820.975 MHz.
Channel Modulation
When “Wideband” is enabled, the radio operates
with a 4 kHz maximum deviation between 821.000
and 824.975 MHz and 5 kHz maximum deviation for
all other frequencies. When it is disabled, deviation is
5 kHz with all frequencies.
PTT ID
This enables or disables the PTT ID.
Transmission Trunking
Selecting “Disabled” removes the hang time at
the end of a normal conversation. This forces the radio
to always contact the control channel when seeking a
channel grant instead of being able to key up on the
hang time of another conversation.
System Lists
Clicking System Lists in the left pane or that
button in the General screen displays the screens used
to program the various lists that are unique for each
SMARTNET/SmartZone system. Refer to Section
3.6.7 for more information on these lists.
Dynamic Regrouping
Enable For This System - When this box is checked,
a dynamic regrouping channel is enabled. This is a
SMARTNET channel which has the corresponding
talk group dynamically set by the dispatcher.
Zone - The physical zone containing the dynamic
regrouping channel. The value is selected on the
Channel Parameters screen.
Channel - The physical channel used for dynamic
regrouping. The value is selected on the Channel
Parameters screen.
Affiliation Type
Automatic - The radio immediately affiliates with
the central controller as soon as it is turned on and
automatically re-affiliates each time the talk group
is changed.
On PTT - The radio affiliates with the central
controller only when the PTT switch is pressed.
Time-Out Timer
This programs the time-out timer setting for the
system. It can be programmed for 0 min, 15 sec up to
3 min, 45 sec or it can be disabled (see Section 2.3.7).
ISW Delay Time
Increasing or decreasing this value changes the
transmission timing of ISWs relative to the reception
of OSWs.
3.6.3 SMARTNET/SMARTZONE SYSTEM
OTHER ID’S SCREEN
The SMARTNET/SmartZone Other ID’s screen
follows, and it programs the these parameters.
