OPERATION
2-19
Revised January 2001
Part No. 001-9800-501
When locked on a site, it is still possible to search
for a different site using the site search function
described in the preceding section. When a new site is
found, the radio is then locked on that site.
2.6 SUPERVISORY TONES
Single Beep (Alert Tone)
•
Power was turned on and a successful power-up
sequence occurred (Section 2.3.2).
•
The time-out timer is about to expire or the penalty
timer has expired (Sections 2.3.7 and 2.4.7).
•
The conversation timer is about to expire (Section
2.4.8).
•
The system received your page but the paged mobile
is not on the air (Section 2.5.7).
•
Telephone interconnect is not operational (Section
2.5.6).
Continuous Tone (Invalid or No Acknowledge
Condition)
•
A transmission is being attempted on an unpro-
grammed channel or a conventional channel
programmed as receive-only.
•
The transmitter is disabled by the busy channel
lockout feature (Section 2.4.5).
•
The transmitter has been disabled by the time-out
timer feature (Section 2.3.7).
•
The transmitter has been disabled by the conversa-
tion timer (Section 2.4.8).
•
An out-of-range condition exists (SMARTNET/
SmartZone only).
•
A transmission is being attempted before the penalty
timer has expired (Section 2.4.7).
•
Dynamic regrouping has been exited but the
dynamic regrouping channel is still selected
(Section 2.5.13).
•
The paged mobile did not acknowledge the page
(Section 2.5.7).
•
The message that was sent has not been acknowl-
edged (Section 2.5.8).
•
The status condition that was sent has not been
acknowledged (Section 2.5.9).
Single Short Medium-Pitch Tone
•
A valid key has been pressed.
Single Short Low-Pitch Tone
•
An invalid key has been pressed.
Six Beeps (Recurring)
•
The page was received (Section 2.5.7).
Three Beeps (Recurring)
•
A unit-to-unit call was received (Section 2.5.4).
Six Beeps
•
The paged radio received the page and acknowl-
edged it (Section 2.5.7).
•
The message that was sent has been received and
acknowledged (Section 2.5.8).
•
The status condition that was sent has been received
and acknowledged (Section 2.5.9).
Two Beeps
•
The emergency alarm condition was acknowledged
(Section 2.5.10).
Gurgle-Like Tone
•
Dynamic regrouping has occurred (Section 2.5.13).
•
Dynamic regrouping has occurred but the
regrouping channel is not selected (Section 2.5.13).
Four Low Tones (Busy Signal)
•
The radio system is busy or a busy condition exists
when making a telephone call.
Four Alternating High and Low Tones
•
A channel is available after a busy condition
occurred (SMARTNET/SmartZone only).
