SMARTNET/SMARTZONE/P25 TRUNKED FEATURES
41
Standard Private Conversation Mode
•
If the mobile being called is not on the air or does
not answer, you will simply not hear a response.
4. When the call is finished or it could not be
completed for some reason, end it by pressing the
Private Call option switch or the F1 (Exit) key.
6.7.3 INITIATING A PAGE
1. With a SMARTNET/SmartZone channel selected,
momentarily press the Call Alert option switch or
select that menu parameter. The alias of the last ID
called is displayed.
2. If required, press the Up/Down switch to display the
desired mobile. The alias of each number is
displayed.
3. Press the PTT switch or the F2 key and one of the
following occur:
•
If five beeps sound, the system received the page
and the paged mobile is on the air and received it.
The page mode is automatically exited.
•
If the system received the page but the called
mobile is not on the air, a single beep sounds and
“NO ACK” is displayed 6 seconds after the PTT
switch is pressed. Auto exit then occurs.
6.8 MESSAGING
NOTE: This feature is not available with P25 trunked
operation.
The messaging feature allows preprogrammed
messages to be sent to a dispatcher. Up to 16 messages
can be preprogrammed, and they are identified by an
alias. If a Message option switch or menu parameter is
programmed, messages are sent as follows:
1. Momentarily press the Message option switch or
select that menu parameter. The alias of the last
message sent is displayed.
2. If required, press the Up/Down switch to display the
desired message. Then send the message by
pressing the F2 key or momentarily pressing the
PTT switch. One of the following events then
occurs:
•
If five beeps sound and “ACK RECVD” is
displayed, the message was received and automat-
ically acknowledged by the system.
•
If after five tries the message is not acknowledged,
a tone sounds and “NO ACK” is displayed.
6.9 SENDING STATUS CONDITIONS
The status feature allows you to manually or
automatically send your current status to your
dispatcher. Up to eight status conditions can be prepro-
grammed, and they are identified by an alias. If the
Status option switch or menu parameter is
programmed, status conditions are sent as follows:
1. Momentarily press the Status option switch or select
that menu parameter. The alias of the current status
condition is displayed.
2. To change the current status, press the Up/Down
switch until the desired status is displayed. Then to
send the status, press the F2 (Select) switch or
momentarily press the PTT switch. One of the
following events then occurs:
•
If five beeps sound and “ACK RCVD” is
displayed, the status was received and acknowl-
edged by the system.
•
If after five tries the message is not acknowledged,
a tone sounds and “NO ACK” is displayed.
6.10 EMERGENCY ALARM AND CALL
6.10.1 INTRODUCTION
Emergency Alarms and Calls are separate func-
tions that can be individually enabled or disabled on
each SMARTNET/SmartZone and P25 Trunked
system. The Emergency option switch (or menu
parameter) is also required for these functions. Emer-
gency Alarms are transmitted on the last selected talk
group, and Emergency Calls are transmitted on the
emergency talk group programmed on the selected
system (or the selected talk group if none is
programmed).
Summary of Contents for 5100 SERIES
Page 47: ......
