3.17. Motorised Valve
You can disassemble the motorised valve by removing its clip.
3.18. Submersion Type NTC
You can disassemble the submersion type NTC by removing its clip.
3.19. Plate Exchanger
After removing the manifold connections of the plate exchanger with a size 4 hex key, you can push
the exchanger back and remove it from the lower service cover.
Suitable Hand Tool: Size 4 Hex Key
3.20. Main Exchanger Tank
After removing all the cable connections of the tank group, unscrew the screws of the upper
connection bracket of the exchanger tank with a cordless drill and slowly tilt the tank to remove it.
Suitable Hand Tool: Cordless screwdriver
3.21. Switch Cover
In cases where it is necessary to remove the switch cover for fault check, pull the cover slightly
towards yourself, remove it from the hinge fitting and tilt it. Then you can take it out.
When putting the cover back on, fit the bottom flanges into the slots and make sure it locks into the
hinge on the top right. The right and left upper panel ends of the cover must fit the inside of the rear
body.
3.22. Pressure Sensor Suitable Hand Tool: AA 17 Wrench
27