E.A.T. C-Sharp, Instructions For Use Manual

Page: 6 / 21

6
SETUP
1. Transport screws
Remove the three
transport screws (15)
from the carbon part of the chassis before installing
the sub-platter (14) , the drive belt (13) and the platter (2) .
The transport screws are used to ensure safe shipping and transport, and should be
reinstalled prior to any future shipment or transportation of the turntable.
2. Protective covers, sub-platter and drive belt installation
The
main bearing shaft (18)
and housing in the
sub-platter (14)
are protected by special plastic
covers. These covers shield against dust and dirt and keep the bearing shaft and housing
sufficiently lubricated. If necessary, lubricate the shaft with grease from the enclosed
accessories. Maximum amount is 0.5 ml . Use the scale on the supplied syringe to measure the
desired quantity and distribute the lubricant evenly.
Remove the protective covers from the main
bearing shaft (18)
and from the
sub-platter (14)
.
Install the sub-platter and the drive belt (13) as shown in the following illustrations.
!