Product Operation
CYCLING BETWEEN SCREENS
There are two methods for cycling between pre-defined screens:
via the menu and via hotkeys.
Screen Cycling Using the SCREEN LI ST
Navigate to the SCREEN LIST menu by holding button six for at
least two seconds when no menu is present (see the figure to the
right). Note that if you only press button six momentarily, the
display cycles to the next screen in your screen rotation. Use the
DOWN
▼
/UP
▲
buttons to move the caret (>). The caret denotes
the selected screen. Press GOTO
►
to remove the SCREEN LIST
and display the selected screen. If you wish to stay on the same
screen, you may either select your currently displayed screen with
the caret and press GOTO
►
, or press CANCEL.
Hold two seconds
Screen Cycling Using Hotkeys
With no menu displayed, press button one to cycle to the previous
screen in your rotation. Likewise, press button six to cycle to the
next screen in your rotation (see the figure on the next page).
Cycling via hotkeys only allows you to display screens that are in
your screen rotation. They are meant to give you quick access to
the screen configurations that are most important to you. If you
wish to access screens that are not in your rotation, use the
SCREEN LIST as described above.
With no menus displayed, pressing button six for two
seconds displays the SCREEN LIST menu, from
which you may switch to, and set up, various screen
configurations.
3-4
EFIS-D100 Pilot’s User Guide
