34
Control possibilities
The Dynaudio Sub 3 provides two
controls to match the frequency
response of the subwoofer and the main
speakers perfectly:
Note
Note: The settings for the cross-
over frequencies just have an
impact on the signal at the
SAT/
SUB Input
! The LFE channel
is just used to reproduce very
low frequent effect signals.
Consequently signals at the
SUB
I/O - LFE/Slave In
are not limited
in their frequency response.
SUB Lowpass
SAT Highpass
50Hz
150Hz
60Hz
Flat 80Hz
•
SUB Lowpass:
The upper cut-off
frequency of the subwoofer, which
can be continuously adjusted
between 50 and 150Hz. Above the
selected cut-off frequency the sound
pressure level decreases rapidly.
•
SAT Highpass:
The lower cut-off
frequency of the main speakers;
60Hz, 80Hz or Flat (neutral) can be
selected. Below the selected cut-off
frequency the sound pressure level
decreases rapidly.
B
ed
Summary of Contents for Sub 3
