18
Connecting a single subwoofer
1.
To connect the SAT/SUB input:
From the preamplifier output of your
processor/receiver, PC or media
player (often marked as Pre Out or
Front Out) connect a stereo RCA
cable to the subwoofer SAT/SUB
Input.
This signal should not be already
processed by the processor/receiver.
Please pay attention to the settings of
your processor/receiver.
2.
To connect the LFE channel:
From the processor or receiver’s
low-level (not a speaker output)
subwoofer output (often marked
as “subwoofer out”, “Sub out” or
“LFE”), connect a mono RCA-to-
RCA cable to the subwoofer input
SUB I/O - LFE/Slave IN.
Please pay attention to the settings of
your processor/receiver.
Set the MODE switch to LFE.
Note
You also can use both connection
types. Both signals will be
combined in the Sub 3 and routed
accordingly.
This allows the Sub 3 to reproduce
both the LFE channel information
as well as the bass range of the
connected satellite speakers
ON
AUTO
GAIN
PHASE
POWER
SUB Lowpass
SAT Highpass
SAT/SUB Input
SAT Output
LFE / Slave IN
OUT
Min
Max
50Hz
150Hz
0° 180°
LEFT
RIGHT
SUB I/O
To Slave
LFE
Slave
60Hz
Flat 80Hz
2.
LFE/SUB Out
1.
Front Out/Pre Out
n
ed
ce
n
ave
Summary of Contents for Sub 3
