page 8
V-3000 PLUS / V-4000 PLUS
P R O F E S S I O N A L P O W E R A M P L I F I E R
MONO BRIDGE OPERATION :
Page 8 / Figure 12 details a mono bridge set-up. Be sure you amplifier and all
other audio equipment are powered down. Flip the Parallel/Stereo/Mono Bridge switch to the Mono Bridge position.
Connect an input signal to channel one. Connect your speaker across the red output binding post on the rear of your
amplifier. Turn your equipment on (your amplifier should always be the last item you turn on). Apply an input source
signal to your amplifier. Use the channel one gain control to regulate your amplifier output.
SPEAKERS
4 OHM MINIMUM
Figure 12
TYPICAL MONO BRIDGE SET-UP
CH-1
Only Input
V-3000 PLUS
Rear Panel
Operating Modes
STEREO OPERATION :
Page 8 / Figure 11 detail examples of a typical stereo set-up. Connect your inputs into
channels one and two of the amplifier. Connect your speakers to the outputs on the rear of the amplifier. Be sure that
your front gain controls are turned down to their lowest level (fully counter-clockwise). Turn your amp on. Turn your input
source level up. Use your front gain controls to regulate the output volume. Be sure not to raise the volume to the clip
level, however an intermittent clip signal is acceptable.
Figure 11
TYPICAL STEREO OUTPUT CONNECTIONS
SPEAKERS
2 OHM MINIMUM
CH-1
Input
V-3000 PLUS
Rear Panel
CH-2
Input
SPEAKERS
2 OHM MINIMUM
Front Views & Rear Views | Introduction | Front Panel
|
Rear Panel | SET UP |
| Protection | Specifications
Operation Mode
