page 7
V-3000 PLUS / V-4000 PLUS
P R O F E S S I O N A L P O W E R A M P L I F I E R
1. Strip back 3/4-inch of the cable casing. Strip off
1/4-inch from the end of each of the conductors
down to bare wire, and insert the brass fittings
(Figure 6).
2. Slide the wire tensioner (D) and the Speakon
coupler (E) through the cable end. See Figure 7.
3. Insert each wire with the brass fittings into the
top of appropriate slot of the connector insert (B)
as shown in Figure 8. Use a 1.5-mm Allen key to
tighten the connection (Figure 9).
4. Be sure to properly match the positive (+) and
negative (-) leads of each wire (Figure 10).
5. Slide the connector insert (B) into the connector
housing (A), making sure that the large notch on
the outer edge of the insert lines up with the
large groove on the inside of the connector
housing. The insert should slide easily through
the housing and out the other side until it
extends approximately 3/4-inch from the end of
the housing.
6. Slide the cable tensioner (D) along the cable and
insert into the housing (A), making sure that the
large notch lines up with the large groove on the
inside of the connector housing (A). The cable
tensioner (D) should slide easily into the housing
until only 3/8-inch of the tensioner (D) extends
from the back end of the connector.
7. Slide the coupler (E) along the cable and screw
it onto the end of the housing (A). Before
tightening, you may want to test the connector to
make sure it has been assembled properly.
SPEAKON ASSEMBLY:
Figure 9
Figure 8
Brass
Inserts
4-
Conductor
Speaker
Cable
Figure 6
A
E
B
C
Figure 7
D
+
+1
-1
Figure 10
-2
+2
+
+1
-1
-2
+2
INPUT BALANCE
You will need a pair of Neutrik Speakon NL4FC connectors. You will also need high-quality two or four conductor Speakon
cable, a pair of needle-nosed pliers and a 1.5-mm Allen key to assemble the Speakon connectors to your speaker wire. To
assemble the Neutrik Speakon NL4FC connector, complete the following steps:
Front Views & Rear Views | Introduction | Front Panel
|
Rear Panel |
| Operation Mode | Protection | Specifications
SET UP
