Dynapac F1000T, Operation & Maintenance Manual

Page: 149 / 238

D 4.0 21
D_4.0_
01_U
S.fm 2
1
-26
When work is finished
- Run the paver empty, then bring it to a stop.
- Turn drive lever (20) to the center position. Move the preselector (12) and selector
(21) to minimum position.
- Switch off cauger (45), vibration (27), tamper (if equipped)(24), lights (25)
and exhaust system (28).
- Lift the screed by using switch (52).
- Retract the screed parts to the basic screed width with switches (50) and (51).
- Use switch (47) and (48) to lift the auger .
- Where applicable, completely extend the levelling cylinders by using switches (54)
and (55).
- Insert the mechanical screed transport
safeguard (74) on both screed lifting
cylinders.
- While operating the tampers at a low
speed, let any material residue drop
out.
Switch the ignition (10) off.
- Switch screed heater (system) off.
- Remove the levelling units and stow
them away in their boxes and close
the boxes.
- Remove all parts that extend beyond the paver width. Secure them if the paver is
to be transported over public roads on a low-bed trailer.
Do not turn the main switch off until 15
seconds after the ignition has been
turned off! The engine electronics re-
quires this length of time to back up data.
- Read and check the operating hour
meter to determine whether mainte-
nance work must be performed (see
chapter F).
- Cover and lock the operating panel.
- Remove material residue from the
screed and the paver and spray all
parts with release agent fluid.
74