14
CP221/271 O221EN5
BEFORE STARTING
Turn the starter switch (21) to position
I
and all warning
lamps should light for about five seconds.
Ensure that the voltmeter (4) indicates at least 12 volt.
Ensure that the fuel gauge (2) shows a reading.
Check that the warning lamps for low brake pressure
(5), oil pressure (6), neutral mode (7) and parking brake
(36) light.
Instruments and lamps
– Checking
Seat belt
Fig. 10 Instrument panel
2. Fuel gauge
4. Voltmeter
5. Warning lamp for low brake air pressure
and low brake fluid level on machines with
level sensor.
6. Oil pressure lamp
7. Neutral lamp
21. Starter button
35. Parking brake knob
36. Warning lamp for parking brake
Fig. 11 Operator’s station
1. Seat belt
2. Anti-slip
Always fasten the seat belt (1) that is provided if a
ROPS (Roll Over Protective Structure) is fitted on the
roller, and wear a protective helmet.
Replace the seat belt if it shows signs of
wear or has been subjected to severe force.
Make sure that anti-slip (2) on the platform
is in good condition; replace with new anti-
slip if friction is poor.
1
2
Make sure that the parking brake knob (35)
is pushed in. If the parking brake is not
applied, the roller may start to roll when
starting the engine on sloping ground.
Parking brake – Check
2 4
5 7 6
21
36 35
