34
CA 252/302/402 M252EN6
LONG-TERM STORAGE
For long-term storage (longer than one month),
the following instructions should be followed.
These instructions apply for storage lasting up
to 6 months.
Before re-commissioning the roller, the points
marked with an asterisk
*
must be restored.
Fig. 60 Protecting the roller from the
elements
*
See the manufacturer’s instructions in the engine
instruction manual, which is supplied together with
the roller.
*
Remove the battery from the roller, clean it’s
exterior, check its electrolyte level and recharge it
once a month.
*
Cover the air cleaner or its opening with plastic or
tape, and cover also the exhaust pipe’s opening.
This is done so as to prevent moisture from
penetrating into the engine.
Fill the fuel tank completely to prevent condensation.
Drain off any condensation water and fill the hydrau-
lic reservoir to the upper mark.
Lubricate the steering joint bearings and the steering
cylinder’s two bearings with grease.
Grease the steering cylinder’s piston with
conservation grease.
Grease also the engine compartment cover’s hin-
ges, the seat slide rails, the engine-speed control
and the forward/reverse control mechanism.
Check that tire pressure is 110 kPa (1,1 kp/cm2),
(16 psi).
*
Place the instrument cover on the steering column.
Cover the entire machine with a tarpaulin, which
should hand some way off the ground. If possible,
store the roller indoors, preferably in a building with a
uniform temperature.
Diesel engine
Battery
Air cleaner, exhaust pipe
Covers, tarpaulin
Fuel tank
Tires (All-weather)
Steering cylinder, hinges etc.
Hydraulic reservoir
Summary of Contents for CA 252
Page 2: ...19 ILF015WO1 ...
