30
CA 252/302/402 M252EN6
Place a receptacle for about 5 litres (5.3 qts)
underneath the drain plug (2).
Save the oil and deposit it in an approved
manner.
Clean and unscrew the filler plug (1) and the drain plug
(2). Allow all of the oil to drain off. Fit the drain plug, and
fill with fresh synthetic oil according to instructions
under the heading “Drum cartridge – checking the oil
level”.
Repeat the procedure on the opposite side.
Ensure that only MOBIL SHC 629 is used in
the cartridges..
EVERY 2000 HOURS OF OPERATION (Yearly)
Place the roller on a level surface. Switch the
engine off and push in the reserve/parking
brake knob for all checking and adjustments
on the roller, unless otherwise specified.
Observe caution when draining hot oil.
Protect your hands.
Obtain a container for collecting the used fluid. The con-
tainer should have a volume of at least 60 litres (16 gal).
A suitable container may be an empty oil drum or similar
item which is placed beside the roller. The fluid then
runs in a hose from the drainage plug (1) to the oil drum,
after the plug (2) has been removed and the tap opened.
Save the oil and deposit it in an approved
manner.
Fill up with fresh hydraulic fluid as per the instructions
under the heading “Hydraulic reservoir – Check fluid
level”.
Replace the hydraulic fluid filters at the same time.
Start the diesel engine and operate the various hydraulic
functions.
Make sure there is adequate ventilation
(extraction) if the diesel engine is run in-
doors.
(Risk of carbon monoxide poisoning)
Check the fluid level and top up if necessary.
Hydraulic reservoir
– Fluid change
Fig. 50 Hydraulic reservoir, underside
1. Drainage tap
2. Plug
Drum cartridge
– Oil change
1
2
1
Position the machine level so that the indicator pin (1)
on the inside of the drum is aligned with the top of the
drum frame.
Fig. 51 Left side of drum
1. Indicator pin
Fig. 52 Right side of the drum
1. Filler plug
2. Drain plug
3. Level plug
1
2
3
Summary of Contents for CA 252
Page 2: ...19 ILF015WO1 ...
