Dynapac BG49 Series, Instructions And Spare Parts Catalogue

Page: 8 / 22

INSTRUCTION MANUAL – BG49
File: 4700369449_ENG_NO.doc Page 8 / 22 Original instructions
- Connect the cable 21 on the stop engine cable and
- Connect the cable 22 on the engine body.
INSTALLATION OF OPERATING HANDLE
- Take off the 4 x nuts and washers from the base . Then put in place the operating handle and secure it
with washers and nuts ( 17mm Flat spanner).
- Slide the electrical cable inside the protective tube of the operating handle and connect it to the ON/OFF
switch.
- Hook up the throttle cable for each particular engine (Cruciformscrew driver) . When throttle control is
fully pushed in, engine throttle control should be against idle adjustment stop . If adjustment in cable
length is necessary , make adjustment at handle end of the cable (3mm Screw driver).
- Dismantle the V-belt cover (10mm Flat spanner). Then slide the clutch cable through the adjusting screw
of the guard ring and through the tensioning lever hole . By hand let the tensioning lever bend slightly the
V-belt and then tighten the tensioning lever screw (3mm Screw driver). Ensure that when the dead man
handle is grip the V belt is normally tensioned and when it is released the V belt is not tensioned.
If necessary make adjustment of tensioning by the adjusting screws situated at each end of the cable .
- Put in place the V-belt cover.
- Turn trowel control knob in a counter-clockwise direction until rotation is impossible. Take off the pin from
the fork, slide the cable into the fork and then secure it with the pin.
TEST
CAUTION
ALWAYS HAVE THE THROTTLE AT IDLE WHEN STARTING ENGINE
- Check engine oil level.
- Fill gasoline tank.
- Set ON/OFF switches on "ON" position (on engine and operating handle).
- Start the engine (see engine operating manual) and if necessary adjust throttle cable and clutch cable for
proper operation.
- Set the engine to 3000 rpm (see engine instruction manual).
WORKSHOP TOOLS
- 1x Screw driver 5 mm width.
- 1x 10mm Flat spanner.
- 1x 17mm Flat spanner.
- 2x 13mm Flat spanner.
- 1x 3mm Hexagonal spanner.
- 1x 5mm Hexagonal spanner.
- 1x Screw driver 3 mm width.
- 1x Cruciform screw driver.