GBK59690 DX Heavy Duty Switch Joystick
Installation Manual Issue 5
Warning:
The DX-RJM-HD is not fully sealed against water ingress. Care should be taken to use the DX-RJM-
HD indoors and out of contact with water and other liquids.
4.2 Connect
The DX-RJM-HD is a DX Secondary Remote. It must be installed in a DX System that already has a DX
Power Module and a DX Master Remote.
Figure 3: Connecting to the DX System
1. Make sure that the DX System is off.
2. Connect the DX-RJM-HD with a DX BUS cable to a DX Module. This will usually be either the DX
Power Module or the DX Master Remote, but it can be any other module with an available DX
BUS socket.
Figure 4: Connecting to the DX-RJM-HD
Note:
A DX BUS cable is not supplied with the DX-RJM-HD and must be ordered separately. The correct
length of the DX BUS cable is dependent on the position of the module to which the heavy duty
joystick is connected.
Page 8 - Installation
