15-023
www.powercommander.com
2012 HD V-rod PCV - 4
7
Install the rear fender cover.
8
Use the supplied velcro to secure the PCV in place (Fig. D).
Make sure to use the alcohol swab to clean the surface before attaching.
9
Locate the stock rear O2 sensor connection and unplug it (Fig. D).
This is a BLACK 4 pin connector.
10 Plug one of the Dynojet O2 Optimizers into the stock wiring harness.
The Optimizers are indexed so they can not be installed incorrectly.
FIG.D
11 Locate the stock front O2 sensor connection and unplug it (Fig. E).
This is a WHITE 4 pin connector located on the left side of the radiator. It may
be necessary to remove the radiator shroud to gain access.
12 Plug one of the Dynojet O2 Optimizers into the stock wiring harness.
The stock O2 sensors will no longer be connected to anything and can be
removed from the exhaust if desired.
13 Reinstall seat.
FIG.E
O2
Follow these instructions when installing the Autotune kit (part #AT-100)
1
Lift the main seat up. Remove the rear fender cover.
2
Using the supplied velcro install the Autotune module on top of the PCV
module(Fig F.)
FIG.F
