Dynafit TLT SPEEDFIT, User Instructions

Page: 4 / 17

to provide an accurate fit, you can move the buckle catches forward or backward by
simply removing the screw on the back, repositioning the buckle catches on a different
hole, and securing them again with the original screw.
• WALK/RUN MODE: Once the cables are correctly adjusted, simply open the cuff buckle
to simultaneously release the cuff and unlock the ski/walk mechanism. This simple and
fast movement will allow you to walk or run freely with incredible agility.
WARNING: verify that cuff’s buckle was tight to the cuff. The ULTRA LOCK SYSTEM
2.0 is thought to be closer to the cuff compared to the 1.0 version. If you don’t see
the buckle properly extended as the picture (1), simply pull the cable forward. This
shrewdness will extend the lifespan and the reliability of your boot. The buckle works
better if the velcro band is fully open.
• DOWNHILL SKI MODE: First of all lock the ultra lock strap and, just later, the upper buck-
le. To simultaneously tighten the cuff width and lock the ski/walk mechanism, simply close
the cuff buckle. Once the buckle is closed, it will automatically lock the cuff into place.
TF – CUSTOM LIGHT: Always refer to an authorized Dynafit retailer when molding your
liners. In order to get the best fit and to be covered by the warranty we recommend
using only blowing heat towers shown on the picture (2) and not others heating
systems.
MOLDING LINERS: Remove the footbed (if present) before heating the liner. Warm up
the liners with air blowing heating system. Do all shaping with the liners in the boots, do
not warm up the liners separately from the shells to avoid damaging them. During the
heating time prepare your feet wearing the socks you usually use during the activity, put
the toe caps on your toes in order to gain room on the toe box (3) and the Nylon socks
useful to slip into the boot (4). Just a bit before the count down is finishing, take out
the first boot and leave the second one on the machine. Place the footbeds (if needed)
back into the boot before stepping in. Place your foot into the boot helping you with a
shoehorn. Close the boot into downhill mode to a level of medium tightness. Remain in a
stable standing position and wait at least 10 minutes to allow the liner to cool down and
walking on the heels in the first 10 seconds. Repeat these points for the second boot.
External abrasion on Thermoformable liners is normal. In the boot box, special patches
are provided to reinforce your liners if you start to see abrasion occurring on the outside
of the liners.
CARE AND MAINTENANCE OF YOUR DYNAFIT BOOTS:
• Use only mild soap and water to clean your boots.
• If the liners are wet, remove them from the shells. Take out the footbeds and place
them in a warm, dry place. Keep them away from direct heat sources, such as radia-
tors, fireplaces, or ovens, as this may cause damage or change the fit.
• Before storing the boots for an extended period of time, be sure the liners and shells
xare completely dry. Place the liners in the shells and close the buckles loosely.
• With time and sun exposure, the coloration of the boots may change. Especially the