13
Battery:
Always make sure the power switch is in the “off” position whenever the
off-road electric scooter is not in use. Never store the product in outdoor conditions,
never store it in the rain, and never store the product in freezing or below freezing
temperatures. These low temperatures will permanently damage the battery.
WARNING
Always ensure that you are in a safe open area to ride before
you engage the throttle. Never twist the throttle without being on the off-road electric
scooter in a balanced, ready to ride position with both hands on the handlebar con-
trols. Failure to follow these instructions may result in risk of serious injury or even
death, and it may also damage your off-road electric scooter and void your warranty.
WARNING
An off-road electric scooter that does not work properly
can cause you to lose control and fall. Inspect the entire off-road electric scooter
thoroughly before every ride, and do not ride the off-road electric scooter until any
problem has been corrected.
DETAILED MAINTENANCE & REPAIR
WARNING:
Turn the power switch “OFF” before
conducting any maintenance procedures.
Adjusting the Brake
Tools required; 10mm wrench
1.
To adjust the brake cable tension, turn the
adjusting barrel on the brake lever clockwise
(to loosen) or counter-clockwise (to tighten).
Only turn the adjusting barrel in small
increments until the desired adjustment
is reached. If the brake continues to need
adjustment, proceed to the next step.
WARNING
Keep brakes properly adjusted and in good working condition
at all times. Check to make sure that the brakes are functioning properly after any
adjustment and before riding.
2.
If the brake cable is still either too tight or too
loose, use a 10mm wrench to loosen the brake
cable pinch bolt for further adjustment on the
cable. Ensure that the 10mm nut is securely
tightened after the adjustment is made.
WARNING
The brake lever contains a
safety switch to cut power to the motor when the
brake is applied. In an emergency, applying the brake will always stop the product
from moving. Do not disable or replace this lever with anything other than a genuine
original replacement part.