9
ASSEMBLY
WARNING
Children can be harmed by small parts, sharp edges and sharp
points in the vehicle’s unassembled state, or by electrical items.
WARNING
In the unassembled state, this package contains small parts.
Adult assembly is required, children should not handle parts, or help in assembly of
the vehicle.
WARNING
A loose stem bolt can cause a loss of steering control and result
in serious injury or death. The stem must be tight enough for the wedge nut to bite
into the inner surface of the steer tube.
WARNING
Overtightening the stem bolt or headset assembly may cause
damage to the scooter and/or injury to the rider.
Attaching the Handlebars
Tools required: One (1) 6mm Allen wrench.
1. Remove the plastic cap on the stem
and insert the handlebar assembly into
the top of the steerer tube (which is the
top end of the front fork), taking care
to ensure that the wedge nut is in the
proper position.
WARNING
The “Minimum
Insertion” mark on stem must not be
visible above the top of the headset.
If the stem is extended beyond this
mark, the stem may break or damage
the fork’s steerer tube, which could
cause you to lose control and fall.
2. Tighten down the hexagonal bolt
securely with the 6mm Allen key.
Note:
• Make sure the cable wires are
smooth and out of the way before
attaching to the handlebar.
• Make sure that the wires to be
positioned on the front of the
handlebar and the handlebar are
facing forward and are vertical
to the wheel base.