10
Handlebar Steer Tube Assembly
Tools required: 5 mm Allen key, 10 mm wrench
1. Slide the clamp onto the handlebar
steerer tube as shown. Depress the push
button located on the rear of the fork
stem and attach the handlebar steerer
tube onto the fork stem. The push button
should align with the locator hole on
the handlebar steerer tube and lock the
steerer tube securely in place.
Note: The push button should pop out
through the locator hole.
2. Tighten the clamp bolts with the 5mm
Allen key and 10 mm wrench. Tighten
bolts evenly and securely.
Note: Do not completely tighten each
bolt, one at a time. Rather, please
alternate tightening each bolt until
they are all completely tightened to
assure they are evenly tightened.
Note: The open end of the clamp
should be located in the same
direction as the slot on the handlebar
steerer tube before you tighten it.
3. Attach the handlebar (a) vertically and
horizontally onto handlebar steer tube
clamp (b), install handlebar clamp and
hardware (c&d) and tighten evenly and
securely with the 5mm Allen key and
10mm wrench.
Note: Make sure that the cable wires
are smooth and out of the way before
attaching to the handlebar.
Note: The threaded area on the
handlebar must be covered by the
handlebar clamp(b).
