IPX Series DSP Multichannel Networking Power
Amplifier
Technical data | en
27
Bosch Security Systems, Inc.
Installation manual
2018.04 | 01 | F.01U.330.705
8.5
IPX5:4, IPX10:4, IPX10:8, and IPX20:4
DIGITAL SIGNAL PROCESSING
Sampling rate
48 kHz/96 kHz, OMNEO/Dante synchronized
Signal delay/latency
Analog In to Speaker Out, 48 kHz/96
kHz
0.70 ms/0.53 ms
Dante Network Latency
typ. 1.00 ms
Signal Processing
User EQ
12 filters per channel, selectable as PEQ, Lo-Shelv, Hi-Shelv, Lo-ShelvQ,
Hi-ShelvQ, Hi-Pass, Lo-Pass and Notch; 2 filters of them with additional
asymmetric filter type
User Delay
0 to 2000 ms per channel (units: µs, ms, s, cm, m, inches, feet)
Array EQ
5 filters per channel, selectable as PEQ, Lo-Shelv, Hi-Shelv, Lo-ShelvQ, Hi-
ShelvQ, Hi-Pass, Lo-Pass, and All-Pass
Array Delay
0 to 500 ms per channel (units: µs, ms, s, cm, m, inches, feet)
Speaker EQ
10 filters per channel, selectable as PEQ, Lo-Shelv, Hi-Shelv, Hi-Pass, Lo-
Pass and All-Pass
Speaker X-Over
Hi-Pass, and Lo-Pass per channel, 6/12/18/24/30/36/42/48 dB Bessel/
Butterworth, 12/24/48 dB Linkwitz-Riley; Alignment Delay, 0 to 20 ms per
channel
Speaker FIR
Up to 1025 taps, Linear Phase Filter, Linear Phase Brickwall X-Over
Speaker Limiters
Peak Anticipation Limiter and RMS/TEMP Limiter per channel
Other Functions
Source Selection and Mix, Level, Mute, Polarity, Sine and Noise
Generator, Pilot Tone Generator and Detection, Level Meters, Impedance
Measurement and Load Monitoring
Memory
DSP Presets
1 F 20 User
Speaker-Pool Presets
30 Speaker Settings
Source Supervision and Fallback
Pilot Tone supervision at Analog and OMNEO/Dante inputs, switchover to
alternative Source Selection
CONNECTIVITY
Network
Type
2 x Neutrik EtherCON/RJ45, redundant PRIMARY/SECONDARY
General
1000base-T/100base-TX, integrated switch
Network Audio Inputs
8 channels, 48/96 kHz, OMNEO/Dante format
Network Audio Outputs (Monitor)
2 channels, 48/96 kHz, OMNEO/Dante format
Mains Input
1 x Neutrik powerCON-HC
Summary of Contents for IPX10:4
Page 2: ......
