Paging Console
10 Owner‘s Manual
3 Operation
3.1 LC-display
Depending on the actual operational status of the PROMATRIX 8000 system, the LC-display shows
information on time, operation mode, user notes, setting up, fault messages including precise device /
module specification, etc.
Status messages
During error free operation of the PROMATRIX 8000 system the LC-display shows the name / description
of the paging console in line 1 and the current date and time in line 2.
Error messages
An error within the PROMATRIX 8000 system is indicated at the paging console in following way:
•
The FAULT LED is blinking and a warning signal sounds via the integrated loudspeaker.
•
The description of the error is indicated in the LC-display. If several errors exist at the same time the
corresponding error messages are indicated alternating.
•
By pressing the STOP button the acoustic warning signal stops and the FAULT LED changes from
blinking to permanently on.
•
The FAULT LED lights as long as the error in the PROMATRIX 8000 system exists.
3.2 Operation mode
After power on the paging console is in
operation mode
. For configuring the paging console the
setup
mode
is used. Several key functions differ between setup mode and operation mode, see following table.
Operation mode
Setup mode
n
(ON)
The
n
button turns the system‘s power on or off. Turning the
power on can take several seconds. The ON LED blinks while
the system boots. The ON LED lights steadily when the sys-
tem is operational. To prevent inadvertent erroneous operat-
ing pressing the key for at least 3 seconds is necessary when
turning the power off. It is also possible to prohibit the opera-
tion of the ON key during the configuration procedure.
In setup mode this
button is used to
select the previous
parameter/menu
item.
ESC (STOP)
Pressing the STOP button cancels an output alarm signal or
text message. Only events that were triggered from a specific
paging console can be stopped from the exact terminal with
the exception of the directing station. This terminal allows
canceling all signals.
This button is used
to cancel the edit-
ing of a parameter
or to move upwards
in the menu tree.
